Bimetallic Screw For Plastic With Less 50% Reinforced Additives DW-S2
DW-S2 Bimetallic Screw for Plastic with Less 50% Reinforced Additives
Comparing DW-S1 bimetallic screw, the DW-S2 PTA bimetallic screw uses even harder steel alloy material, which consists higher composition of tungsten element.
Tungsten element has good electrical and thermal conductivity, corrosion resistance, low vapor pressure, and is prone to forming hard carbides. The melting point of tungsten is about 3422 ° C, which is the highest among all non alloy metals, making it extremely important in high-temperature applications. Tungsten has a very high hardness and can maintain its hardness even at high temperatures, making it an ideal material for manufacturing hard alloys. The density of tungsten is about 19.3 g/cm ³, second only to osmium and iridium, ranking third among many metals, making it suitable for use as a weight or protective material. In addition, tungsten can maintain good conductivity and thermal conductivity at high temperatures, making it suitable for electrical applications that require high temperature resistance. Tungsten also has good chemical stability and is not easily corroded by most acids and bases, making it suitable for use in harsh environments.

Technical Parameters
Product Name : Bimetallic Screw
Material : JYN1 + DW-S2 Series Alloy
Suitable Machine: Injection / Extrusion / Blowing ...
Available Size: Φ14-400mm, Length <8,000mm
Process Method: PTA Spray
Surface Hardness:54-58 HRC
Surface Roughness: < Ra 0.8
Screw Straightness: < 0.02mm/m
Advantages
By spraying high quality alloy powder on screw flight with layer thickness 1.5-2.0mm, screws can get higher performance in both wearing & corrosion resistant performance.
Applications
General plastics & engineering plastics with below 50% glass fibre filling.
Comparison of DW-S Series Alloy
At this stage, we have DW-S1, DW-S2 and DW-S3 alloy types and treatments for wear fighting.
|
Type |
Alloy Components |
Hardness (HRC) |
Abrasion Resistance |
Corrosion Resistance |
Application |
|
DW-S1 |
Ni. Cr, Si |
52– 56 |
x |
x |
Recycling & engineering plastics with less than 30% reinforced additives. |
|
DW-S2 |
Ni, Cr, W |
54– 58 |
xx |
x |
Engineering plastics, reinforced additives less than 50%. |
|
DW-S3 |
Co, Cr, W |
44 – 48 |
x |
xx |
Reinforced additives and corrosive plastics less than 20%. |
Suitability: (x good) to (xxx excellent)

Hot Tags: bimetallic screw for plastic with less 50% reinforced additives dw-s2, China bimetallic screw for plastic with less 50% reinforced additives dw-s2 manufacturers, suppliers, factory, bimetallic screw for plastic with less 30 reinforced additives dw s1, bimetallic screw
Next
No InformationYou Might Also Like
Send Inquiry












